1
Installation & Operations Manual for Pursuit Side View Mirror
Pursuit Mirror # 18071 & 18072
Contents:
Left Mirror and Clamp Assembly
Right Mirror and Clamp Assembly
Temporarily remove this socket head bolt using a 8mm
Allen Wrench
Installation:
Open clamp and place around roll
cage tube. Make sure the rubber
shim is in place in the thick half of
the clamp.
2.
3.
4.
Close clamp around roll cage
tube, put the bolt through the
hole, and place large rubber
washer over the end of the bolt.
Using the 8mm wrench,
screw the bolt into the
mirror but do not tighten
yet.
Rubber Shim
1.
Initial Adjustment:
Rotate mirror on clamp so that it is
level. When you are satisfied with
the location and angle, tighten
bolt.
Slide mirror up or down Roll Cage
tube to desired location.
1
2
3
The Mirror Housing has 3 detent positions.
Position 1 is for the drivers side, position 2
is passenger side, and position 3 is
completely folded. Once the detent position
is selected you can fine tune the viewing
angle by moving the mirror glass within the
housing.
For 1.75” Clamp Only!
Place the self adhesive thin
rubber shim in this location.