4
1.
Place 2 metal spacers on the tabs on the bumper as
shown above.
Bumper Mount and Vehicle Assembly
Side View
2.
Line up the holes on the bumper mount and place
on top of the bumper. Bolt together with M8x30mm hex
head bolts, washers, and M8 locknuts. Make sure the
spacers are between the bumper mount and bumper.
3.
Undo the two roll cage bolts holding the A pillers of
the vehicle together, and use these bolts to bolt the roll
cage mounts to the vehicle. The clamps should open
towards the cab of the vehicle.
4.
Open all four clamps and place basket assembly on
the on the clamps. Lock all four clamps.
6.
Adjust the hood rack angle by loosening the bolt on
the front riser stems and pushing up or down on the
front of the rack. Adjust clamps and brackets as
necessary, then tighten all bolts. We recommend no
more than 5% of slope to the hood rack.
Locking Bolt
5
. Adjust the width of the extendable tubes (G) so
they stick out just past the clamps. (If necessary)
