B43A623002
CR
203
2
LI-
Mn
3V
+
CE0
700
Par
t-N
o.:
B43
A62
300
2
SKR
2W
433
,4
33
MH
z
Sei
pA
ntri
ebs
tec
hni
kG
m
ww
w.s
eip
.co
m
www.seip.com
English
Wall Transmitter SKR2W, 433MHz, rolling Code
channel 1
channel 2
Fixing the frame to the wall
Frame
Push-Button
Plugging the push-button into the frame
Changing the battery
Removing the push-button
from the frame
Be careful not to damage the
push-button or the frame!
Opening the batteries‘ cover
Use a small coin to turn the
cover
Removing the battery
Use a small screwdriver to lever the
battery
Take care to insert the
new battery with the
plus-pole up!
Usage
The wall transmitter SKR2W can be used with garage door opera tors
and external receivers Type SKR433 on 433 MHz with rolling-code (door
operators TM60, TS75, TS100, SE130TS, receivers EKR1MD, EKR4MD,
EKR4SP433, EKR1MCG, EKR1MCT, SKR1ST433).
How it works
This wall transmitter works like a 2-channel hand-transmitter. It can be
used to operate two different garage door operators. The programming
is achieved by programming in the same way as for a hand-transmitter:
the learning mode needs to be started on the receiver; then press
channel 1 or chan nel 2 on the wall reciever - the signal will
automatically be registered and stored in the receivers‘ memory.
Information on how to start the learning-process on a receiver may be
obtained from the receivers‘ instructions.
The wall transmitter must be inserted into the frame before it
can be programmed!
Procedure
We recommend programming the wall transmitter to the garage
door ope rator before fi xing it to the wall. You can then check the
transmitter’s range at different locations before fi nally mounting it in it’s
fi nal position.
Make sure you push transmitter into its‘ frame before programming,
otherwise it cannot be used!
With external receivers
the transmitter
MUST
be programmed before
fi xing it to the wall!
(Most external receivers require the transmiter to be
held very close to it, to start the programming procedure)
Sending a remote-signal to the receiver
Data
Power Supply
3V
Battery
CR 2032
Frequency
433 MHz AM
Encoding
Rollender Code
Channles
2
Intelligent Security & Fire Ltd.
