Seiler Evolution Zoom, User Manual

Page: 9 / 36

9
PLEASE NOTE: Take care when handling the Fiber optic cable (only applicable to the configuration with
halogen bulb source). It is made up of extremely fine, very sensitive fibers. Improper use, repeated stretching
and bending movements can cause damages that affect the performance or even rendering it useless.
PLEASE NOTE: The optical module is assembled in a sealed block. Maintenance activities shall only be
performed by the AUTHORIZED TECHNICAL ASSISTANCE.
PLEASE NOTE: The control box, the illumination box and the pantographic arm must be handled carefully,
because the external surfaces of these modules can be easily damaged. A sharp impact on these surfaces may
result in scratches or other damages.
The optical module is the most delicate part. Take care during use, transportation or handling. It is fitted to a
specific support (Figure 3).
Installing the Equipment
PLEASE NOTE:
Before any attempt to assemble or install the Seiler Evolution Zoom Microscope, please read
carefully and thoroughly the present User’s Guide.
The assembly and install activities shall only be performed by authorized technicians.
Seiler Instrument shall NOT be liable for any other type of procedure NOT set forth herein used to install or
assemble this product, nor shall be liable for any misuse of tools.
Unpacking
The Seiler Evolution Zoom Microscope is placed into plywood boxes and foams to protect the equipment during
transportation and storage.
Check the boxes for damage or signs of violation: please contact Seiler Instrument immediately in the event of
any irregularity. The Seiler Evolution Zoom Microscope should ideally be transported into its original packaging,
which shall be kept for further use.
Please check whether the box contains the items set out below:
• This User’s Guide
• Base
• Column
• Control box, illumination box and pantographic arm, already assembled
• Screw to fasten the base to the column
• Accessories, if applicable
• AC Multi-voltage cable 90-240V~
• Protective cover for the optical module
• 1 spare halogen bulb (only for Seiler Evolution Zoom Microscope with halogen bulb)
• 2 5A fuses
•
Fixing pin for optical module support / XY system (*2), optical fiber (for the microscope with halogen bulb
source) and electric cables already installed
• Optical module (discrete or zoom) already connected to its support system
• 1 pair of knobs of the optical module
• 1 pair of autoclave protectors knobs of the optical module
• Multifunctional pedal (*1) and/or (*2)