9-3
(2) When Designing a Mount
Design a mount so that the fulcrum for rotation is located as shown in
Figure 9-2
.
Fulcrum for rotation
Figure 9-2 Designing a Mount
9.1.2
Opening and Closing the Autocutter Unit
Open the autocutter unit to insert sheets of paper manually or to clear paper jams. To open the
autocutter unit, lift the part shown in
Figure 9-3
. Care should be taken to avoid causing damage to the
platen. Before closing the autocutter unit, verify that the print head is down. Close the autocutter unit
until it clicks.
Note 1: Do not raise the head when the autocutter unit is closed. Set the head up lever to the position
shown in
Figure 9-4
to clear paper jams.
Figure 9-3 Opening and Closing of Autocutter Unit Figure 9-4 Head up Lever Position
Summary of Contents for LTP1245R-C384-E
