TECHNICAL GUIDE
●
How to remove and install the Balance complete with stud
How to remove
How to install
1. Initial phase
1. Initial phase
Move the stud support toward the arrow marked
Set a new balance complete with stud to the
direction until it touches the balance cock.
main plate.
2. Make sure that the outer coil is not removed from
2. Set the Balance cock and tighten the balance
the regulator arm.
cock screw.
3. Using sturdy tweezers, push the stud outward
3. Temporarily set the stud to the stud support.
from the direction of the arrow shown in the
Make sure that the balance spring passes outside
illustration until it is removed from the stud support.
the regulator pin.
* Be careful not to damage the balance spring.
4. Using sturdy tweezers, set the stud to the stud
support and press it down.
Make sure that the outer coil passes through
the regulator pin slot.
* Be careful not to damage the balance spring.
4. Unscrew the Balance cock screw and remove the
Balance cock.
12/16
Cal.6R15A/B
