Seiki SC-1200AU6DS, Instruction Manual

Page: 10 / 28

10
WATER PRESSURE
Minimum inlet water pressure is 0.04MPa
Maximum inlet water pressure is 1.0MPa
NOTE:
The new hose-sets supplied with the appliance are to be used and that old
hose-sets should not be reused.
Before installing your appliance, read all safety instructions in this manual,
especially the sections on electrical safety and installation.
The minimum measurements needed for this dishwasher installation are as below:
GETTING STARTED
POSITIONING THE APPLIANCE
• This dishwasher is freestanding. Position it close to an existing water inlet and
drain connection and be sure that there is a power supply nearby.
• The back of the appliance should lean against the wall behind. The sides along
any adjacent walls. The appliance can be recessed under a single benchtop.
• Make sure water hoses or power cables arent underneath the appliance.
LEVELLING THE APPLIANCE
• Make sure to position the dishwasher on a level and stable ground. If the floor
is uneven you can adjust the feet by twisting it as if to screw in the feet to the
product, either clockwise or counter-clockwise to adjust the feet up or down
until appliance is completely level. (the maximum height adjustment is 20mm)
WATER CONNECTION
Connect the water supply hose to a threaded 3/4”connector.
During operation, the dishwasher will heat up the appliance to the required
temperature so please be sure that the
hose it not kinked or squashed and
tightly fastened in place. If the hose is
new or has not been used be sure to
let the water run for a little bit to
clear the hose of any impurities.
MINIMUM MEASUREMENTS
Width: 598mm
Depth: 610mm
Height: 845mm
Depth:
1175mm (open Door)