F l o o r
F l o o r
F l o o r
F l o o r
HZ3480R0TX
Wall-Mount Ironing Center
Assembly Instructions
1 screw MUST BE directly
mounted into a wall stud. Wall
anchor is not needed when
mounting into a wall stud.
Step1: Measure the wall and
mark the location of the center of
each mounting holes. See
Figure 2.
NOTICE
If your wall studs are 12”
apart, please make sure the
top 2 holes are located on wall
stud. However, at least one
top hole must located on a
wall stud.
Using the level, make sure that
all marks are level on the wall.
Step 2: Using power drill and
3/16
″
drill bit, drill three 3/16
″
holes through the wallboard at
the mounting hole marks.
Figure 1-Screw Hole Location
Drill
three 3/16"
holes
into wall
