SEI ADVISOR AE100, Programming And Installation Manual

Page: 33 / 46

CONNECTION TO RADIO
J1 RJ45 RADIO CABLE
1 PTT - BRN - RECORDER ONLY - NORMAL OPERATION - NO CONNECTION
- USING WITH ADVISOR ENCODE - CONNECT TO RADIO PTT
- IF MIC AUDIO IS LIVE ALL THE TIME THEN CONNECT TO RADIO PTT
AND SETUP GATING IN AUDIO MENU (SEE PAGE 11)
2 TX AUDIO OUT - BLU - NOT NEEDED UNLESS ADVISOR ENCODE IS USED
3 RX AUDIO IN - YEL - SQUELCHED AUDIO NOT ADJUSTED BY VOLUME CONTROL
(IF NEEDED, THE RX AUDIO CAN BE GATED BY CONNECTING PIN 7 TO A
CTCSS DECODE OR A COR PIN)
4 TX AUDIO IN - GRN - CONNECT TO MIC AUDIO IN THE RADIO
(A JUMPER, WITH AN INLINE CONNECTOR, IS PROVIDED TO CONNECT TO THE
BACK OF THE MIC JACK IN THE RADIO SO THE CONTROL HEAD CAN STILL BE REMOVED)
(IF TX AUDIO IS HARD TO CONNECT TO IN THE RADIO THEN A MODULAR
MIC JUNCTION BOX CAN BE USED TO PICK UP THE MIC AUDIO IF THE
MIC HAS A MODULAR CONNECTOR, PAGE 18)
5 POWER - RED - B+ - 12 - 15VDC
6 GROUND - BLK - GROUND
7 OPTIONAL RX AUDIO GATE - ORG
(IF NO SQUELCHED AUDIO IS AVAILABLE THEN PIN 7 CAN CONNECT TO COR OR CTCSS
DECODE TO GATE THE RX AUDIO) (SEE PAGE 11)
8 IGNITION SENSE - WHT 12 - 15VDC
(IN A MOBILE INSTALLATION, CONNECT TO AN IGNITION SOURCE,
IN A STATION INSTALLATION CONNECT TO B+)
J3 RJ45 RADIO THE ADVISOR ENCODER/DECODER PLUGS INTO J3 (IF IT IS USED)
(NOT USED IN MOBILE INSTALLATIONS
TABLE OF CONTENTS