Sega Virtua Fighter 4 Evolution, Installation, Instruction And Service Manual

Page: 9 / 38

4
www.seuservice.com
5
www.seuservice.com
INSTALLATION INSTRUCTIONS
1)
Turn off power and unplug machine. Open all access panels. Locate the original game
Power Supply, Game BD, I/O BD, Sound BD etc… Remove these items from your cabinet.
Remove all artwork from cabinet. Clean Cabinet Exterior and repair as necessary to assure
good appearance.
2)
Remove all existing harnesses. Install a new JAMMA Harness (Recommended). Please
note that this harness is NOT SUPPLIED with your kit. DO NOT connect the 5vdc, 12vdc,
GND or any other power line from the JAMMA Harness to the Power Supply. Note: If you
are using a VGA compatible monitor you can run your VGA cable directly to the monitor or
connect it to your JVS JAMMA interface for RGB conversion to your JAMMA cables.
3)
Install the Components supplied in your kit (Game BD, Power Supply, Amp, Transformer
etc.). Follow the wiring diagram for proper electrical connection (located at the end of the kit
manual). Be careful to fasten all components securely. Route wires in a manner not to allow
for pinching or binding. Secure wires once connected.
Vacuum out or clean bottom of cabinet of dirt & miscellaneous parts (e.g.
screws, loose coins / tokens, etc.).
Remove all exterior decals and repair any cabinet damage. Repaint
cabinet if necessary. Remove the Monitor Plexi or if your game plexi has
Silk-screened artwork, you will need to strip it off.
4) Connect your cabinet’s existing Service Switch Bracket Assy to the Kit Harness (Follow Diagram).
Please note that you MUST USE a COIN METER for the game system to properly accept coins
(Refer to Diagrams and Service Bulletin included in this manual).
5) Remove all Joystick Buttons and Pushbuttons from your Control Panel. Remove the existing overlay.
Clean off all glue residues, and fill in or plug existing holes to give you a blank work area for your
new game.
6) Install your Control Panel Art supplied with the kit. Cut holes in the overlay where controls are to
be installed. Install and connect your controls. Please note that Joysticks and Pushbuttons are NOT
SUPPLIED with your kit. You will need to supply 2ea 8way Joysticks, 2ea Start Buttons, and 2ea
Punch, Kick and Defense buttons.
7) Connect your Coin Switches to the game harness following the diagram in the back of the manual.
8) Turn on Power to the game and check for proper voltages on either connector entering
the Game BD
Filter BD. The proper voltages are: 5.1vdc between Yellow and White, 3.30vdc between
Brown and White. Adjust where necessary. Adjustment can be made at the Power Supply by
using an insulated flat screwdriver. Turn clockwise to increase. Turn counter-clockwise to
decrease.