Fitting the Cooktop
1
After the hole is cut in the bench, fit
the cooktop into the opening.
2
The cooktop does not require "fixing"
to the bench - it will stay in position
under its own weight.
3
Ensure that the flange of the
sheetmetal base of the cooktop rests
on top of the bench all the way
around.
4 DO NOT
seal the cooktop into the
bench - the small opening around the
perimeter of the glass hob, and
across the rear of the stainless steel
hob, is required to allow combustion
air to enter the cooktop.
Gas Connection
Natural Gas Cooktops
1
The cooktop is supplied with a
regulator which must be fitted at the
inlet of the cooktop.
Propane Cooktops
1
The cooktop is supplied with a short
length of copper pipe which
incorporates a pressure test point.
This must be fitted at the inlet of the
cooktop.
This cooktop is NOT suitable for use
with a flexible gas connection.
Electrical connection
(electronic ignition models only)
1
Each cooktop is supplied fitted with a
standard 3-pin 240Vac plug and
1-1.2m of lead.
2
A conventional 240Vac 10A 3-pin
GPO must be fitted.
3
Ensure that the polarity of the power
supply is corrrect.
4
Electrical wiring and fittings must be
installed by a licensed electrician,
and in accordance with the relevant
electrical standards and regulations.
9
SEELEY INTERNATIONAL
– OWNER’S & INSTALLATION MANUAL
INSTALLATION INSTRUCTIONS
cont.
