- 23 -
14A4A4-00090E-3
2)
Open FrameType Panel Mounting Procedures
■
4.3
” Open Frame / 5.7” Open Frame
①
Align the hole of the unit angle with the stud bolts of the panel in 4 locations and tighten the
nuts.
*Angles are options for 3.5
” products.
②
Adjust the height of the touch screen (LCD) with the angle.
■Open Frame Type Panel Opening Example
Design and arrange the design so that the touch screen is a little inward (about 0.3mm
recommended) from the sheet side so that the sheet side does not push the touch screen.
③
Pull the tail of the design sheet key through the opening of the panel and apply the design
sheet key so that the display center and the transparent window of the design sheet key are
aligned.
To avoid getting air bubbles between the panel and the design key, apply to one side and
carefully work to the other by lightly pressing down with your hands or a rubber roller.
To avoid damage to the design sheet key tail, do not directly come in contact with the edge of the panel
opening. If damaged, it may cause a switch or an LED performance defect.
The tail should be folded so it forms an
“R” and is not folded flat.
Nuts
Stud Bolts
Panel
Stud bolts
Angles
LCD
Touchscreen
Adjust with Angle
