11
3) When the TIMER window flashes, set the desired hours by using the 10 or 1 buttons to
select the desired time, then press the SET button to finalize your choice.
NOTE:
• For faster and more accurate setting of the temperature and time, the Sedona Combo
has 2 separate buttons of 10 and 1. The buttons under the 10 represent increments of
ten, whereas the buttons under the 1 represent increments of one.
• You may set the dehydrating time up to 99 hours.
• The Sedona Combo has a Continuous Operation function which allows you to
continuously dehydrate for more than 99 hours. To enable this function, press and
hold the 10 up button until CO is displayed.
• The CO function will dehydrate for a maximum of 150 hours.
• The default setting for Fast Mode: 68°C (155°F) for 1 hour.
• The default setting for Raw Mode: 47°C (117°F) for 10 hours.
• The Sedona Combo will save your settings for next use even when you turn off the
dehydrator.
6.
UP/DOWN (10,1)
buttons are for setting the temperature or the hours for the timer-
one short press will change the number by 10 or 1, and when the button is pressed for
more than 1 second the number will continuously change.
7.
TRAY
button is used to select which compartment will be activated, which is indicated by
the lights to the right of the TRAY button.
• When the top light is lit GREEN, the upper compartment is activated.
• When the bottom light is lit GREEN, the lower compartment is activated.
• When both tray lights are lit, this indicates both upper and lower compartments are
activated for dehydrating.
You can choose to dehydrate up to 9 trays of foods by selecting both compartments or up
to 4 trays of food in either the upper half or the lower half of the unit in order to conserve
energy when dehydrating smaller quantities of food.
1) Insert the Closed Tray in the middle slot (just above the white indicators on both
right and left sides, where the trays slide in and out) to divide the Sedona Combo into
two 4-tray dehydrating chambers.
2) Press the TRAY button to select which fan with heating coil will be active.
3) Load the trays into the chosen half of Sedona according to which fan with heating
mechanism is selected.
NOTE:
• The default setting of Sedona is whole (upper half + lower half).
•
Since Sedona Combo is equipped with two independent fans with heating mechanisms,
the Sedona Combo can be used to dehydrate food in the upper or lower half of the unit
when divided.
• The Sedona Combo will not remember your tray setting, and it will go back to whole
when you turn the Sedona Combo off.
• We recommend using the upper half only when drying up to 4 trays.