returns to the standby status.
Note:
Please insert the TF card before you use it. Make sure there is enough light in
the surrounding and the camera is not blocked by any obstructions. Keep the
camera upright and stable. And the object should be more than 50cm from the
camera.
d.
Record video
: In the video mode (push switch DOWN), press button (1) to enter
into the standby status, and green light is on, the blue light will be on after 2 seconds,
this means the machine is in video recording standby mode. Shortly press the button
(1), the blue light will flash, this means the machine is recording video. Press the
button (1) again, the blue light will keep on, it will stop recording and save the file.
The device will automatically save file every 50 minutes, and continue the video
recording.
Note:
In order to ensure good sound for recording, do not block the microphone hole.
The other operation notes are as same as C above.
e. voice recording
: in the video or photo standby mode, long press button (1), the red
light will flash, this means the machine is recording voice. Shortly press the button (1)
to stop and save the voice recording.
f. Charge
: Connect to computer USB interface or charger when device is standby or
ON. During charging, the green light flashes slowly. When the battery is fully
recharged, the green light stops flashing.
Note:
The recorder has a built-in high-capacity lithium polymer battery. The battery
strength will not affect the memory. It can be charged at anytime.
For the initial five
times of charging, please fully charge the battery. This will activate the
batteries maximum capacity and maintain the standard working time.
Connect the computer
Set the mode switch to video (push it down), you can connect
the device to the computer. The computer will pop up a
removable disk prompt. To disconnect, please click ‘SAFELY
REMOVE HARDWARE’ on the right bottom corner of the task
bar. Then click to stop the ‘USB mass storage device’. Unplug
the USB when you see the prompt that is safe to disconnect.
Note:
According to the computer or system configuration, there will be slight difference for
the time of identifying removable disk. Please be patient. During this period, please do
not press the button to avoid conflict of computer hardware. If the computer does not
identify the removable disk for a long period of time, disconnect and reconnect the
device. If the computer is unable to identify the hardware, make sure your operating
system, driver and USB cable are all in normal condition. Please make sure to
disconnect the device in accordance with the normal process to avoid the possible
damage for computer and recorder.
