NVR User Manual
44
8
Remote Surveillance
8.1 IE Remote Surveillance by NAT
8.1.1 NAT Settings
①
The NVR shall be powered on and connected to the network.
②
Go to Main Menu
Setup
Network
Network. You can obtain the IP address, Subnet
Mask and Gateway automatically. You can also manually input them according to the
actual network situation. And the IP address shall be in the same network segment as the
network which is used.
③
Set the preferred or alternative DNS Server (Please refer to 5.6.1 Network for details).
④
Go to Main Menu
Setup
Network
NAT tab.
⑤
Enable NAT and input the NAT Server (The default NAT Server is
www.autonat.com
).
⑥
Click “Apply” to save the parameters (Please refer to 5.6.4 NAT for details).
8.1.2 NAT Access
After finishing the NAT settings, you can enter the NAT Server on the remote PC (Input
http://www.autonat.com
to go to the IE client). If you are the first time to access the NAT, the
network will download the ActiveX automatically.
Note:
The WEB client must be in the remote network. It cannot be in the same local
network as that of the NVR, otherwise, access failure will happen.
If you cannot
download and install ActiveX, please refer to FAQ Q8.
After installing ActiveX successfully, it will pop up the login box.
Serial No: The MAC address of the NVR (Go to Main Menu
Information
Network to
check the MAC address of the NVR).
User Name: The login username of NVR. The default username is
admin
.
Password: The login password of NVR. The default password is
123456
.