INSTALLATION
MOUNTING:
1. Locate a suitable place to mount the camera.
2. Remove the hex assembly screws from the SV-6919 camera housing. This will allow the
Camera housing and the Mounting Bracket to be separated from each other
(STEP 1)
3. Remove the camera housing to expose the inner side of the mounting bracket
.(STEP 2)
4. Be sure to double-check behind the mounting surface to make sure that you will not be drilling
into anything behind it.
5. Place the mounting screws in the designated screw holes on the mounting bracket
(STEP3)
and drill them into the mounting surface to secure the mounting bracket to the vehicle.
6. Drill the hole for the camera wiring harness and route the harness through the cable hole on
the mounting bracket
(STEP 3)
and through the mounting surface. Once the mounting bracket
is secured tightly down to the vehicle, the rubber molding on the edges of the bracket will seal
the holes to prevent moisture damage or leaking.
7. Reassemble the camera housing to the mounting bracket
(STEP 4).
STEP 1
STEP 2
STEP 3
STEP 4
Replace camera housing and hex screws
Camera Lens
Camera Housing
Mounting Surface
Mounting Screws
Cable
Install mounting screws in the designated screw
holes on the mounting bracket (Arrows)
Remove hex screws from camera housing
Remove camera housing from mounting bracket
Mounting
Bracket
Cable
Hole
CAMERA:
1. This color CMOS camera is maintenance-free, waterproof (IP-68) and vibration resistant.
2. This camera is completely electronic. There are NO manual adjustments for focus, etc.
3. This camera is equipped with Night Vision to give you better lighting at night time. This plus
the vehicle’s reverse light and the ambient lighting in the area should make it perfect for night
time driving.
