SecurityMan FlashDVR, User Manual

Page: 13 / 27

12
To mount the adventure hat bracket to an object, helmet or wrist, place the Flash-
light DVR into the smoked plastic ring coupler holder, adjust DVR to a desire
position and then secure it down by fastening the latch. Next, loop and wrap the
elastic rubber strap around an object, helmet or wrist, thread elastic rubber strap
through the smoked plastic holder, and then secure by placing the plastic notch
through the belt hole of the rubber strap and thread the rubber strap through the
rubber holder. Lift up the rubber strap from the plastic notch to release the strap.
To mount the bicycle bracket to a handlebar or bar, place the Flashlight DVR in the
plastic holder (plastic notch towards the front of the DVR) and turn the thumb
screw clockwise to secure the DVR to the holder. Then mount the bracket to a
handlebar/bar and secure the bracket to the handlebar/bar by turning the thumb
screw clockwise. Turn the thumb screw counter clockwise to loosen the bracket.
Note: For handlebar/bar that is smaller than the bracket, use the adhesive
3M sticker on the inside of the bracket before securing. Measure the amount
of adhesive needed, cut adhesive according to measurement and then stick
it on the inside of the bracket .
To connect the lanyard to FlashDVR, simply hook the lanyard to the Waterproof
Plug of flashlight DVR and adjust the size by press+hold the leverage ball then
pull on the lanyard to adjust to the desire size.