v2.0 10/26/10
3
INSTALLATION AND OPERATION
CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this
unit. No user serviceable parts are inside.
CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than
specified power source.
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or SecurityTronix at 1-610-429-1511 for
assistance.
3. SPECIAL ATTENTION
a. The installer must comply with electrical safety standards.
b. A minimum 12VDC 1A power supply must be used. AC power cannot be applied.
Using an AC or other incorrect power supply will damage the unit.
c. Only qualified installers are allowed to install and test the unit.
d. The ST-CCTV-VBAC4 is a low voltage product and intended for indoor installations. If
installed outdoors proper safety and lightning grounding are required.
4. WIRING CONNECTIONS
a. The UTP connections to the ST-CCTV-VBAC4 can be done using the unit’s (i)
terminal blocks or (ii) RJ45 connector. The advantage of using the RJ45 connector is
multiple devices can be connected using a single UTP cable. If using the RJ45
connector the wiring order follows the TIA/EIA-568B specification. All UTP wiring
should correspond to the figure below:
This symbol is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions.
This symbol is intended to alert the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a
risk of electrical shock.
