LENS ADJUSTMENTS
Zoom and focus adjustments are made via 2 knobs on the rear panel of the camera.
NOTE:
The tension of these knobs is set at the factory for maximum weather protection.
Do not
loosen the screws which hold the knobs in place.
This could cause the adjustment rod to fall
inside the camera and will void the warranty. If the screws are difficult to turn by hand, pliers
may be used.
WIRING CONNECTIONS
(see diagram on following page)
Connect the power
supply’s DC plug to the camera’s DC jack.
Connect the camera to a viewing source such as a DVR or monitor with a 75
Ω video
cable. RG59 coaxial cable with a 20AWG solid copper center conductor is the cable that
SecurityTronix recommends for all analog CCTV cameras. If a balun must be used, it is
recommended that an active balun be used. With all baluns, the proper wire should be
UTP (Unshielded Twisted Pair) wire such as Cat5, Cat5e or Cat6.
Connect the power supply’s AC plug to a wall outlet supplying 110 ~ 127 volts @ 60Hz.
Adjust the view of the camera according to the requirements of the environment and
surveillance needs.
