6
3
Installation
Important
Before the installation, please make sure the installation surface can sustain at
least 3X weight of the bracket and the camera.
3.1
Dome Camera Installation Introduction
Please follow the steps listed below. See Figure 3-1.
Step 1
Turn clockwise to remove the decoration ring from the snap joints.
Step 2
Please take the installation position map in the accessories bag, and then paste it on the
ceiling or the wall according to your monitor area requirements.
Step 3
Draw and then dig three plastic expansion bolts holes in the installation surface and then insert
three expansion bolts in the holes. Secure these three bolts firmly. Please draw the cable out
from the cable exit when you install the device.
Step4
Adjust the device installation pedestal to the proper position and then line up the three screw
holes in the device pedestal to the three plastic expansion bolt holes in the installation position.
Put the three self-tapping screws in the three plastic expansion bolts firmly. Loosen the M3X8
cross recessed pan head slot screw of the pedestal to unfasten the preforming. (Do not
remove, loosen a little bit will be OK.). Adjust the lens to the proper monitor angle and then use
the original preforming to turn the M3X8 cross recessed pan head slot screw back.
Step5
Line up the three spigots of the decoration ring to the jags from the bottom to the top and then
turn clockwise until you hear a clear sound
”KA”. Now the installation is complete.
Figure 3-1
3.2
Fixed Camera Installation
This series product supports wall-mount. Please refer to the steps listed below for installation
information. See Figure 3-2. The follow figure is for reference only.
