Page 6
© 2017 Security Brands, Inc. All rights reserved.
care and cleaning for the Sensor:
The sensor requires special care to ensure reliability and a long operating life.
1. Use a soft, clean cloth for cleaning. Use the mildest type of cleaner available.
2. When cleaning, spray the cleaning solution onto the cleaning cloth instead of the unit.
3. Be sure to wipe off any excess liquid from the sensor. Wet spots or areas may affect the sensor’s performance.
WaRnInG: Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could
cause a dangerous electric shock, damage the device, and void the warranty.
Installation:
1. Run 4 wires through the pedestal (or similar mounting hardware).
2. Connect the 4 wires to the Request-to-Exit Sensor according to the Wiring Diagram above.
3. Reattach the Stainless Faceplate to the enclosure taking care not to crimp the wires.
4. Remove clear protective film from the sensor before use.
WaRnInG: do not connect any device that will exceed 1 a @ 30 Vdc.
changing the LEd color Jumper placement:
adjusting the Sensor Range and Trigger Time:
1. The sensor range can be adjusted
from 1.25″ to 4.5″.
2. The trigger time can be adjusted
from 0.5 to 20 seconds or toggle.
noTE: do not force the adjustment
trimpots to turn. only minimal force
is needed.
Standby: Red
Trigger: Green
(default)
Standby: Green
Trigger: Red