Q U I C K S TA R T
G U I D E
3 of 4
Model
14-RTE433
B
Transceiver Reset Procedure
This procedure is used to unpair all devices from the transceiver.
Step 1 - Remove screws and remove transceiver cover.
Step 2 - Press and hold Programming Button until Programming LED starts to
fl
ash.
Button must be held for about 30 seconds. Once
fl
ashing stops, all devices have been
unpaired from transceiver and reset is complete.
Step 3 - Replace transceiver cover and secure screws.
6d
Relay on transceiver should click and
transceiver LED should go out. Pairing
is complete.
LED will
go out
BTN 1BTN
1
BTN 2BTN
2
6c
Hold down both Pairing Buttons until Status LED
fl
ashes. Let go of Button 2 and continue holding
Button 1 only until Status LED
fl
ashes again.
LED will light
solid red
6a
Remove transceiver cover; then
hold down Programming button on
circuit board for 3 seconds and let go.
Your system is ready to use.
INSTALLATION COMPLETE!
N
7
Make sure gate/door path is clear; then
press exit button on RTE unit and con
fi
rm
gate/door opens.
(If nothing happens, repeat
Step 6
)
Unit Enabled
(exit button active)
Unit Disabled
(exit button inactive)
A
The RTE unit can be disabled and re-enabled at any time by taking the
key switch keys and using the key switch located below the exit button.
6b
Remove RTE unit front panel.
CHECK THAT THE GATE PATH IS CLEAR BEFORE
COMPLETING THIS STEP AS IT TRIGGERS THE RELAY!
