![Secureye S-16GE-M-2UG-LD-AI-VLAN User Manual Download Page 10](http://html1.mh-extra.com/html/secureye/s-16ge-m-2ug-ld-ai-vlan/s-16ge-m-2ug-ld-ai-vlan_user-manual_1231891010.webp)
3.2SFP Port connection
S-16GE-M-2UG-LD-AI-VLAN
SFP port only support Gigabit fiber module.
Recommended use of standard SFP module products
The process of installing a fiber module on a switch is as follows:
First, grasp the optic fiber module from the side, insert it smoothly along the SFP
port slot until the optic fiber module and switch are in close contact;
Second, confirm the Rx and Tx ports of the fiber module when connecting, insert
one end of the fiber into the Rx and Tx ports correspondingly, ensure that the Tx
and Rx ends of the interface are connected correctly and the other end of the fiber
is connected to another device;
Third, please check the corresponding indicator light status after power on. If the
light blinking that the link is properly connected, if the light is off , the link is failure,
pleasecheck the line to confirm that the corresponding equipment is enabled.
Note
:
Does not allow excessive bending fiber, the radius of curvature should not be
less than 10cm;
Ensure the cleanliness of the fiber surface;
Please do not look directly into the optical fiber connector with your eyes as this
may cause eye injury
3.3 Check before power on
Check whether the outlet power supply meets the switch specifications;
Check the power, switches, racks and other equipment have been properly
grounded;
Check whether the switch and other network devices are connected properly
3.4 Device initialization
The switch automatically initializes when the power switch is turned on.
Indicator will appear the following situation:
After the power is turned on, the power indicator remains on, the other indicator
is off at this time;
After about 1 second, all lights except for the power light turn on for about 35
seconds and then turn off; when the SYS light goes flashing, the system runs
normally
Port LEDs indicates the connection status of each port, indicating that the
switch has started to work normally