INSTALLATION
MOUNTING:
1. The VS-185 is design to be mounted on the License Plate bezel of a Honda Accord vehicle. If
you wish to mount this camera on any other vehicle, double check the mounting location to
see if the camera will fit on your vehicle in your location of choice.
2. Unclip and remove the factory license plate illumination lamp using a screw driver or panel
removing tool
(STEP 1)
3. Connect the license plate lamp illumination wires of the VS-185 to the factory license plate
illumination lamp harness that was connected to the factory lamp
(STEP 2)
4. Route the wiring harness into the vehicle
(STEP 3)
. There may be an existing factory rubber
grommet that you can use to run the wiring into the trunk area. If you have to drill a hole,
make sure to double check behind the drilling location before drilling. Once the hole is drilled
and the wiring is run into the vehicle, seal the edges of the hole with silicon or caulking to
prevent moisture damage.
5. Snap the camera securely into place in the mounting location
(STEP 4)
. If need be, you can
adjust the bracket for a better viewing angle after the camera is powered up
STEP 1
STEP 2
STEP 3
STEP 4
Snap the VS-185 camera into place
Camera Lens
Remove factory
license plate lamp
Connect the camera lamp illumination wires
Route the wiring
harness into the
vehicle
Adjustable
Bracket
Mounting Surface
Illumination
Wires
Cable
CAMERA:
1. The color CMOS camera is maintenance-free, waterproof (IP-68) and vibration resistant.
2. This camera is designed to work well in day time or night time conditions.
3. The camera is completely electronic. There are NO manual adjustments for focus, etc.
