Rev. 20190204A
To
11 of 25
U
NLOCKING THE
USB
IN
A
DMIN
M
ODE
CAUTION
: Possible deletion of all data, settings, and both PINs. After ten
failed attempts to unlock the USB, it will reset to the blank factory setting.
Refer to
Brute Force Hacking Detection
on page 15.
NOTE
: Unlocking the USB drive with the Admin PIN will delete the User PIN. For security
reasons, we highly recommend that a new User PIN be created immediately after
unplugging the USB drive. Refer to the next heading on this page.
1. Press and hold down
1
-and then press
[
]
2. Enter the Admin PIN. [
]
3. Press
[ briefly, then
]
If unsuccessful [ briefly ]
Insert into your computer within 30 seconds.
NOTE: If your computer goes into sleep mode while the USB is unlocked, the USB may
lock after some time depending on your power management settings regarding
the USB port.
C
REATING OR
C
HANGING A
U
SER
PIN
IN
A
DMIN
M
ODE
For PIN requirements refer to page 5.
1. Unlock the USB KP with the Admin PIN. [ ] (Refer to the previous procedure.)
2. Press
[
]
3. Enter a new
User PIN
. [
]
4. Press
[ ]
5. Re-enter the
User PIN
[
]
6. Press
[ briefly];
Or if the PIN does not meet the requirements [
]
If unsuccessful
, such as the PINs don’t match [ briefly ]
If successful, the User PIN is now added or changed (and the USB is still locked). To
verify which PINs currently exist, see
Verifying which PINs have Been Set
on page 14.
L
OCKING THE
USB
IN
A
DMIN
M
ODE
The procedure for locking the USB KP is the same for both modes, User and Admin.
Refer to
on page 7.
