6
Copyright 2016 - 2018 Secura, Inc. All rights reserved.
www.thesecura.com
3. Close the lid, place the kettle onto the base and plug the power cord into an outlet.
4. Press the ON/OFF switch into the ON position. The switch will illuminate and remain
on until the water comes to a boil (212°F). Once the water boils, the kettle shuts off
automatically, the indicator light turns off and the ON/OFF switch returns to the OFF
position.
5. Carefully remove the kettle from the base, discard the water and allow the kettle to cool for
1 minute.
6. Repeat steps 1-5 again to remove any production residue from the interior of the kettle.
7. Unplug the power cord and allow the kettle to cool completely.
NOTE:
Do not consume the water used during the preparation process. It should be
discarded immediately. While not harmful, this is the initial cleaning process and the water
may taste unpleasant.
USING YOUR KETTLE
1. Remove the kettle from the base.
2. Press the LID RELEASE and fi ll the kettle with cold water until it reaches the correct
amount between 0.5-liters (2 cups) minimum and 1.7-liters (7 cups) maximum.
3. Close the lid, place the kettle onto the base and plug the power cord into an outlet.
4. Press the ON/OFF switch into the ON position. The switch will illuminate and remain
on until the water comes to a boil (212°F). Once the water boils, the kettle shuts off
automatically, the indicator light turns off and the ON/OFF switch returns to the OFF
position.
5. Carefully remove the kettle from the base and pour water as needed.
6. Return the kettle to the base.
7. To reheat the water, refi ll if required and repeat steps 3 – 6.
8. Unplug the power cord when done and allow the kettle to cool completely.
BOIL DRY PROTECTION FEATURE
If the kettle is empty or contains less than 0.5-liters (2 cups) of water, the BOIL DRY
PROTECTION SENSOR will activate, and the kettle will shut-off automatically. This protects
the kettle from damage due to overheating.
If this happens, please do the following:
1. Lift the ON/OFF switch into the OFF position, if needed.
2. Unplug the base.
3. Wait at least 10 minutes for the temperature sensor to reset before attempting to use the
kettle.
