11
4
3
3. Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 2¾ in. (70 mm). Be sure to drill into the center of the studs.
4.
Install wall plate
12
using four lag bolts
13
and four washers
14
. Tighten the lag bolts only until they are pulled firmly against the wall plate.
CAUTION:
Avoid potential personal injury or property damage! All lag bolts
13
MUST BE firmly tightened to prevent unwanted movement
of the wall plate
12
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
CAUTION:
Improper use could reduce the holding power of the lag bolt.
DO NOT over-tighten the lag bolts
.
Go to STEP 3 on PAGE 14.
7/32 in.
(5.5 mm)
2
¾
in. (70 mm)
12
14
13
Summary of Contents for QMT25
Page 33: ...33 2B 12 09 203 mm 8 203 x 203 x 406 mm 8 x 8 x 16 406 mm 16 75 mm 3 3 14 15...
Page 36: ...36 2B 12 09 203 mm 8 203 x 203 x 406 mm 8 x 8 x 16 406 mm 16 75 mm 3 3 14 15...
Page 38: ...38 3 4 1 6 1 1 1 2 1 3 1 4 2A 10 16 5 8 51 x 102 2 x 4 38 x 89 1 x 3 406 16 70 2...
Page 39: ...39 2B 12 09 203 8 203 x 203 x 406 8 x 8 x 16 406 16 75 3 3 14 15...
