Installation Instructions Cont’d
—
Spectrum – Light Mirrors
Page 2 of 4
Step 1
| Remove M6 screw in back side of Door Plate and separate Door
Plate from Mounting Block.
Step 2
| Install Threaded Standoffs onto Door Plate using M6-1.0x20
screws. Ensure that alignment features are correctly aligned. Tighten to
5.7-7.6 ft-lbs.
Note: It is recommended to use a medium strength threadlocker.
Step 3
| Install Door Plate onto Mounting Block. Ensure that alignment pins
on Mounting Block are properly seated in alignment holes on Door Plate.
Confirm that when viewing mount from the front, Sector Seven logo is
aligned horizontally and Threaded Standoffs on the back side are stacked
vertically. Connect Door Plate to Mounting Block using four M6-1.0x20
screws. Tighten to 5.7-7.6 ft-lbs.
Note: It is recommended to use a medium strength threadlocker.
Step 4
| Install foam Door Plate Gasket onto back side of Door Plate.
Ensure that gasket is oriented correctly by matching up cutouts in Door
Plate Gasket with hole locations on Door Plate.
Step 5
| Back out set screw in Jeep Mount arm until it no longer extends
into mirror mounting hole.
Step 6
| Insert end of ball pivot into mounting hole in arm of Jeep Mount.
Tighten set screw to 5.7 – 7.5 ft-lbs. (Note: After assembly is complete, it
may be necessary to loosen the set screw in order to access the ball pivot
stiffness adjustment bolt to tighten or loosen it as needed. Be sure to
retorque set screw to 5.7 – 7.5 ft-lbs.)