16
4.3.4. Preparation before shrinking cycle
1) Position the universal sliding support on the heating station.
2) Install on it the support ring that corresponds to the Shrinkfit toolholder’s taper.
Please refer to the latest Machining Navigator ‘Tooling Systems’ or to the
Machining Navigator ‘Update’ to select the appropriate support ring.
3) Choose the adapted heat focusing stopper that corresponds to the tool shank
diameter.
Note: 5 heat focusing stoppers are supplied with each device, capacities: Ø 3-6,
Ø 8-14, Ø 16-18, Ø 20-25, Ø 32 mm.
4) Install it into the location diameter in the inductor housing. Turn it around to
lock it on the inductor housing.
4.3.5. Minimal and maximal shrinkfit assembly’s height
Minimum height between
inductor and flange location
160 mm
Maximum height between
inductor and main plate
620 mm
Maximum ‘A length’ of the
assembly ‘tool’
460 mm
Universal
sliding
support
Support ring
620
460
160
