ENFORCER Outdoor Piezoelectric Request-to-Exit Pushbuttons
2
SECO-LARM U.S.A., Inc.
1x Piezoelectric push button
2x Wires for manual override
1x Manual
2x Mounting screws
Operating voltage
12~24VDC
Contact rating
2.5A@24 VAC/VDC
Ring
LED
Standby Red
Active Green
Output time
1~30s, Toggle
IP rating
IP65
Operating temperature
32°~158° F (0°~70° C)
Plate material
Stainless steel
Weight
Single-Gang 3.5-oz (99g)
Single-Gang
w/ manual override
4-oz
(113g)
Slimline 2.6-oz
(74g)
Slimline
w/ manual override
3.1-oz
(88g)
Overview:
Introduction:
Parts List:
Installation:
*SD-6176-SSVQ and SD-6276-SSVQ with Manual Override button shown, other models similar.
Slimline
Single-Gang
Side View
Rear View
*SD-6176-SSVQ and SD-6276-SSVQ only.
1.
Prepare wiring to provide 12~24 VDC power and connect devices to the relay outputs.
NOTE:
The device includes one relay with two outputs. Outputs trigger simultaneously but can be configured
independently. To set the output modes, see Relay Output Modes on page 3.
2.
Remove the plastic cover from the rear of the switch and carefully pierce the rubber grommet.
3.
SD-6176-SSVQ and SD-6276-SSVQ
: Wire the manual override button. See page 3.
4.
Wire the switch according to the diagram on the right.
5.
Connect (-) and (+) to a 12~24 VDC power source.
6.
Connect other devices to Output 1 or 2.
7.
Replace the plastic switch cover and screw the plate
onto the mounting surface
Terminal Block
LED Ring
Piezoelectric
pushbutton
Manual
Override
Button*
Manual
Override
Button*
Timer
Adjustment
Output mode
Selection
LED color
Selection
Terminal
blocks
Relay adjust
Buzzer
adjust
(Plastic switch
cover removed)
1
5
/
8
" (42mm)
1
5
/
8
" (42mm)
2
3
/
4
" (70mm)
4
1
/
2
"
(114mm
)
