SECO-LARM Mini Electric Door Strike
SECO-LARM U.S.A., Inc.
4
Electric strike does not activate
Unmount the strike and check that the two wires are
connected properly
Ensure the wires are connected to a 12VDC source
Use a multimeter to test that the strike is receiving the
proper voltage and amperage. If it is not, it may be
necessary to use heavier gauge wires, or increase the
output of the power supply
Make sure the activation device (keypad, pushbutton
switch, etc.) is working properly
Door does not open when the electric strike
is activated
Check that the door latch is operating properly and
replace if necessary
The position of the electric strike may need to be adjusted
by moving it or adding washers or shims
Troubleshooting:
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
®
PITGW1
MI_SD-991A-D1Q_170821.docx
Surface-Mount Electric Rim Strike
Vandal Resistant Outdoor Access Control Keypad
SD-998C-NUQ
SK-1123-SDQ
Electric Door Strike for
Metal Doors
Push-to-Exit Bar
Single Door Maglock
600-lb Holding Force
SD-995C
SD-961A-36
E-941SA-600
Also Available from
SECO-LARM
®
:
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2017 SECO-LARM U.S.A., Inc. All
rights reserved.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
