ENFORCER 4-in-1 HD Turret Cameras (TVI, CVI, AHD, Analog)
SECO-LARM U.S.A., Inc.
3
1.
Use the camera within the given temperature
and voltage limits.
2.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
3.
Do not subject the camera to strong vibrations.
4.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
Before Starting:
1.
Run a 12VDC power supply wire and a video
cable with a male BNC connector through the
wall to where the camera is to be mounted.
2.
Loosen the outer case ring and remove the
case from the base.
NOTE:
The camera ball is NOT attached to the case
or the base. It sits loose inside the case. Therefore,
be very careful when removing the case from the
base. Do not drop the camera ball.
3.
Mount the base to the wall using the three
included mounting screws. If the wall is made
of dry wall, brick, or similar material, it may be
necessary to use the included screw anchors.
4.
Run the camera’s BNC and power connectors
through the camera base, and connect to the
video and power wires that were run through
the wall.
Installation:
6.
Put the case over the camera ball and onto the base.
7.
Holding the case loosely on the base, turn the camera
ball to the desired direction. Use a small screwdriver to
adjust the zoom and focus of the camera ball if needed,
via the holes marked "ZOOM" and "FOCUS" on the top
of the camera ball (EV-Y2501-AMWQ,
EV-Y2251-AMWQ, and EV-Y2501-AMGQ only).
NOTE:
Before securing installation, make sure to check both the day
and night images. Adjust the camera ball in a way so that there
are no objects blocking the camera’s view.
8.
Use the OSD controller joystick to adjust camera
settings (see the separate OSD manual).
9.
Once the ball is pointing in the desired direction, tighten
the outer case ring to secure the camera in its position.
10.
Do a final test of the video camera and monitor.
Overview:
Camera ball
Case
Base
Female BNC connector
DC Jack
OSD Controller
EV-Y2501-A2WQ, EV-Y2501-A2GQ, and EV-Y2251-A2WQ shown above.
Screws
Important:
Do not cut any wires as the warranty will be voided.
OSD Controller Settings:
To set format via the OSD controller, move the
controller in the direction of the desired setting, hold
for 5 seconds, and release when the camera restarts.
See chart below.
Direction Format
Setting
Up
AHD
Down CVBS/Analog
Left TVI
Right CVI
UP
NOTE:
Do not press joystick in when setting different modes.
BNC
Connector
Camera
