ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Bullet Cameras
SECO-LARM U.S.A., Inc.
3
Overview:
Installation:
Important:
Do not cut any wires as the warranty will be voided.
1.
Run a 12VDC power supply wire and a video cable
with a male BNC connector to the wall or ceiling
where the camera is to be mounted.
2.
Temporarily connect the camera to the 12VDC
power supply.
3.
Temporarily connect the camera’s female BNC
connector to the video cable’s male BNC connector.
4.
While watching the monitor, hold the camera against
the wall or ceiling by hand where it is to be mounted,
then turn the camera until it is certain that this
mounting location is correct.
5.
Adjust the zoom and focus to desired settings. See
"Zoom and Focus Adjustment" (EV-Y1501-AMWQ
only).
6.
Use the OSD controller's joystick to adjust the camera
settings. See "OSD Controller Settings". (For more
information, see separate OSD manual).
7.
Use a pencil and the included mounting template
sticker to mark the mounting location. Disconnect the
12VDC power supply and video cable.
8.
Mount the camera mounting base to the wall using the
included mounting screws.
OSD Controller Settings:
To set format via the OSD controller, move the
controller in the direction of the desired setting,
hold for 5 seconds, and release when the
camera restarts.
See chart below.
Direction Format
Setting
Up
AHD
Down CVBS/Analog
Left TVI
Right CVI
UP
DC Jack
Female BNC
Connector
OSD controller
Sunshield screw
Sunshield
Mounting arm
adjustment screw
Camera angle
adjustment screw
Mounting
screws
EV-Y1501-AMWQ shown above.
Zoom & Focus Adjustment*:
To adjust the Zoom and Focus, open the Zoom/Focus compartment
located on the bottom of the camera. Once within the compartment,
use a flathead screwdriver to loosen the Zoom and Focus screws to
allow for adjustment.
Focus
To focus in on close objects, push
the focus screw right towards "N".
To focus out on far objects, push
the screw right towards "F".
Zoom
To zoom in, push the zoom screw
left towards "T". To zoom out, push the
screw right towards "W".
1.
Use the camera within the given temperature
and voltage limits.
2.
Do not point the camera at the sun.
3.
Do not subject the camera to strong vibrations.
4.
Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals.
Before Starting:
Mounting base
*EV-Y1501-AMWQ only.
(Continued next page)
Zoom
Focus
To adjust the camera angle and positioning,
loosen the camera angle adjustment screw
and mounting arm adjustment screw.
Rotate the camera and position the
mounting arm in the desired position and
retighten the screws.
Camera arm position:
Camera Angle and Positioning:
Mounting arm
adjustment screw
Camera angle:
Camera angle
adjustment screw
N
F
T
W
Base
Front
BNC
Connector
Camera
NOTE:
Do not press joystick in when setting different modes.
Zoom and focus
compartment