ENFORCER IP Wall-Plate Camera
SECO-LARM U.S.A., Inc.
3
Before Starting:
Overview:
Installation:
1.
Please read this manual carefully and keep it for
future reference.
2.
Use the camera within given temperature and
electrical limits.
3.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
4.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
5.
Do not open or disassemble the camera. There
are no field-serviceable parts inside.
6.
Do not drop the camera or subject it to extreme
shock
1.
Run a 12VDC power supply wire and cable with
an RJ45 jack through the wall where the camera
is to be mounted.
2.
Execute "IP Manager" on the PC.
3.
Press the "Find" button. IP cameras connected
to the same router will be searched and listed.
This may take several seconds. Default IP
address is 192.168.1.30.
4.
Right-click the desired product, and press "IP
Change".
5.
Use web port number 80. This is an internal
port.
6.
IP address: You may use Dynamic IP or you
may set Static IP as below:
Typical IP setting is as follows.
IP address.: 192.168.1.10 (you can change the last
column)
Netmask: 255.255.255.0
Gateway: 192.168.1.1
DNS1/2: You can copy the PC's network properties.
This is for internet environments.
7.
Input "admin" for User ID and password
NOTE:
It is recommended that you change the
default password.
8.
Press "Change" to save settings and allow 10s
for changes to appear.
9.
Right-click the desired device and click "Open
Web Page".
10.
Enter Username / Password.
11.
Click "Live" on top right of the screen.
12.
Click yes for "ActiveX Control".
13.
After the installation of Active X, you will be able
to view the live feed only with Internet Explorer.
14.
Visit http://www.seco-larm.com/EV-N5205-3S4Q
for the Web Admin Manual.
RJ45 Jack
DC Plug
Single-gang
back box
Single-gang
Plate
IMPORTANT:
Do not cut DC Plug or RJ45 jack as warranty will be voided.
Camera
NOTE:
For weather-resistant installation, apply a bead of
silicone sealant (not included) around the rim of the
back box and faceplate edge and ensure that the
back box openings are sealed. Apply a small amount
of sealant below each screw head.