Secabo 109.510.200, Instruction Manual

Page: 4 / 15

Intended use
The Secabo cross laser system is used to facilitate and precisely position
transfer objects and ensure consistent results in longer runs. You can easily
focus the laser beam. After placing the laser in the joint and aligning it with
the surface of the textile before turning it on, you can switch it on and
position it on the textile first.
The knurled screws on the joints are used to fasten and adjust the lasers,
these must not be tightened with tools or other aids, only tighten by hand.
The adjustable lens on the head of the laser allows you to focus the beam
as you wish, after this process hand tighten the knurled screws on the joint.
The height is also adjusted using this joint. With the single cross laser, this
can be done very easily by loosening the knurled screw on the side of the
rod until the desired height is reached and then tightening it hand-tight.
With the double cross laser, the height is adjusted via the fixed joint, which
serves as an intermediate element between the vertical and horizontal rods.
Tighten the knurled screw on the vertical rod only after the desired height
has been reached.
This flexible adjustment can also be found on the Secabo Storage Tray. The
star grip screw allows you to adjust conveniently and easily, and to swivel and
move the storage tray individually in your workspace. Please note that no
more than 2 kilograms should be placed on the tray! Hand-tighten the star
grip screw on the quick-change system before use.
Nepata Vertrieb GmbH | Hochstatt 6-8 | 85283 Wolnzach | Germany | mail@secabo.com | www.secabo.com
4