3
Default 1
Default 1
Default 1
Default 1
Default 1
Default 0
Default 0
4
1
2
3
4
5
8
0
,
#
1
,
#
2
,
#
0
,
#
1-3
,
#
4-6 digits key +facility code virtual card number output
Single Key a 4bit output
Single Key a 8bit output
Turn off Alarm
⑤
Turn on Alarm for 1-3 minutes
IIndicator Light Normally OFF
⑥
Indicator Light Normally ON
Buzzer OFF
⑦
Buzzer ON
Keypad Light Normally OFF
Keypad Light Normally ON
Keypad Light Automatic mode
⑧
Turn Off anti-tamper alarm
Turn On anti-tamper alarm
Unlimited Error number
10 times errors
⑨
locked for 10 minutes
10 times errors alarm for 1-3 minute
User Options Setting
0
,
#
1
,
#
0
,
#
1
,
#
0
,
#
1
,
#
2
,
#
0
,
#
1
,
#
0
,
#
1
,
#
2
,
#
Note
：
①
For each effective unlocking operation, change the switch state once, and keep locking the state all the time.
②
Only valid under the card opening mode, open the door after reading 2-10pcs cards continuously.
③
The device will take ID number and card number as the initial data, add 1 card, then automatically increase
ID number and card number, continue to increase the next card, until the specified number of cards have been
added, but the increasing ID number can not exceed 2000, and the input ID card quantities-1<=2000.
④
After unlocking, it enter the normal working state.
⑤
When the alarm is turned off, it is invalid for the anti-tamper, anti-stress and door status alarm.
⑥
Refers to static state, operation in accordance with the normal instructions.
⑦
After entering administrator password, the buzzer will sound normally.
⑧
Pressing key or reading card once, the keypad light will be turned off after 30s delay. However, when the
keypad light is off, it means turn on the keypad when press the keypad at first, without any other function.
⑨
Start the corresponding operation after 10 errors continuously, including: try to enter invalid administrator
password, user password, anti-stress password or read invalid card.
10
.
Various Working Modes Application
There are 3 working modes about the device, such as reader mode, standalone access control mode,
anti-passback mode, default standalone access control.
The device can be connected to the external reader through Wiegand and realize various function. The
information such as card number and password are stored inside the device, external reader is only an input
device for reading card or password. The external reader can be connected to multiple devices in parallel, but
the function are the same, the operation on the local device and external readers are different,depending on the
mode setting.
6/8
