5
0#
Set to normal mode
0
(1-3)#
Set the alarm time to 1-3 minutes
6
0#
To disable door open detection
0
1#
To enable door open detection
7
0#
To set normal mode
0
1#
To set lock mode
2#
TO set alarm output
Enter Master Operation Mode: *(6 digits administrator code)#
Menu
Parameters or operation steps
Function
Default
0
（ new administrator password ） #,( new
administrator password again)#
Modify administrator password
888888
1
* read card,…,*
Quickly add user card
(ID No.)#，read card,…,*
Add user card with ID No.
(ID No.)#(user pin)#,…,*
Add user pin with ID No.
2
Read card,…,*
Quick delete card
(ID No.)#,…,*
Delete card or pin with ID No.
0000#，*
Delete all the users
3
0#
Entry by card
2
1#
Entry by card with pin together
2#
Entry by card or pin
3#
Entry by only pin
4
0#
to set door relay time 50ms
To set door relay time 50ms
0
（1-98）#
To set door relay time 1-98s
99#
To set the switch mode
Fault
phenomenon
Fault Cause
Reason & Solution
Unusual
Indicator light
Power voltage too low or too much interference
Change to qualified power supply,
cable or restoring power
No response
Continuously swipe in lock mode or input the pin
code more than 10 times
Restoring power or wait for 10 min.
Abnormal
unlocking
Wrong electric lock mode
Set the different modes follow the
way of different electric locks
Wrong wiring
Follow the right way of wiring
Can’t enter
administrator
mode
Make sure the red indicator light normally on
before press *
Follow the right operation way
Forget the master password
Factory reset
Can’t enter
by card
Set the mode of entry by pin
Set the right open mode
Too much interference of power or power voltage
too low
Change to good power supply or
cable
Can’t enter
by pin
1. Need to set the pin first, master setting or users
change the 1234 to new 6 digits pin by themselves
Set or change the user pin
password
3.
Input the wrong pin password
Input the right pin password
Digits key
invalid
To set the entry by card or card & pin
Set the right entry mode
5. Simple Troubleshooting
