EN
To continue building, you need the tube, the
adjustment rod with a small screw and two screws
with the knob. Use the included screwdriver as a tool.
Place the tube on the mount. The lateral threads on
the tube should be put in the two intakes of the
mount. Make sure that the mount points to the rear
(1) and the tube opening to the front (2). Otherwise
you will not be able to align the telescope with the
aperture upwards.
Insert the two screws with the knob laterally through the holes
of the mount into the thread of the tube. Turn the screws to
the right respectively in order to tighten them firmly.
Slide the adjustment
rod (1) through the
spigot (2) of the
mount. Make sure
that the fastening
eye of the rod (3)
points towards the
tube-opening. Slide
the screw through
the hole (3) in the
thread and tighten it.
x
Loosen and remove the screw heads on the front tube and
put the viewfinder on the screws.
Then screw the heads back on the screws so that the
viewfinder is firmly on the tube.
Make sure that the narrow end points towards the focuser.
This is the opening to look into.
