Seat Toledo 2019, Owner'S Manual, Page: 95 / 300

Fuses and bulbs
Fig. 105 Remove the bulb holder.
The rear lid must be open to change the
bulbs.
You can access the bulb holder for the inner
tail lights through the inside of the rear lid.
–
Check which of the bulbs is defective.
–
Open the cover to access the lights, turning
it by hand in the direction indicated by the
arrows.
–
Access the lights by disconnecting the con-
nector
1
›››
Fig. 105

and unscrewing
the bulb holder
›››
Fig. 105

. Take care not
to lose the bulb holder retaining screw.
–
Change the bulbs
›››
page 93 .
Changing bulbs
Fig. 106
Position of the bulbs in the bulb hold-
er
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
bulbs
›››
table on page 93 .
–
Lightly press the defective bulb into the
bulb holder, then turn it anti-clockwise and
remove it.
–
Fit the new bulb, pressing it into the bulb
holder and turn it clockwise as far as it will
go.
–
Use a cloth to remove any fingerprints from
the glass part of the bulb.
–
Check that the new bulb works properly.
–
Re-install the bulb holder
›››
page 93 .
–
Screw in the bulb holder.
Position of the bulbs
›››
Fig. 106 Bulb function
A
Reversing lights: P21W
B
Side lights: R5W LL
C
Fog lights: P21W
Note
One of the two sides may not be fitted with
a fog light, depending on the country and
type of driving. In this case, the hole for the
light is covered.
Fitting the bulb-holder
–
Position the bulb holder on the tail light and
align it so that it is securely seated.
–
Screw in the bulb holder using the corre-
sponding screw.
–
Make sure the connector is correctly in
place.
–
Close the inner trim cover.
»
93