Seat Tarraco 2020, Owner'S Manual

Page: 53 / 424

Self-help
CAUTION
●
Damaged or dirty windscreen wipers
could scratch the glass.
●
If products containing solvents, rough
sponges or sharp objects are used to clean
the blades, the graphite layer will be dam-
aged.
●
Never use fuel, nail varnish remover, paint
thinner or similar products to clean the win-
dows.
●
In icy conditions, always check that the
wiper blades are not frozen to the glass be-
fore using the wipers. In cold weather, it
may help to leave the vehicle parked with
the wipers in service position
›››
page 49 .
CAUTION
●
To prevent damage to the bonnet and the
wiper arms, only leave them in the service
position.
●
Before driving, always lower the wiper
arms.
Jump start
Jump leads
The jump lead must have a sufficient wire
cross section.
If the engine fails to start because of a dis-
charged battery, the battery can be connec-
ted to the battery of another vehicle to start
the engine.
Jump leads must comply with standard DIN
72553 (see cable manufacturer's instruc-
tions). The wire cross section must be at least
25 mm
2 for petrol engines and at least
35 mm 2 for diesel engines.
Note
●
The vehicles must not touch each other,
otherwise electricity could flow as soon as
the positive terminals are connected.
●
The discharged battery must be properly
connected to the on-board network.
Jump start: description
Fig. 46 Diagram of connections for vehicles
without Start Stop system
Fig. 47 Diagram of connections for vehicles
with Start Stop system
Jump lead terminal connections
Switch off the ignition of both vehicles
›››
.
Connect one end of the red jump lead to
the positive
+
terminal of the vehicle
with the flat battery
A
›››
Fig. 46 .
Connect the other end of the red jump
lead to the positive terminal
+
in the ve-
hicle providing assistance
B
.
In vehicles without a Start-Stop system:
connect one end of the black jump lead
to the negative terminal
–
of the vehicle
providing the current
B
›››
Fig. 46 .
In vehicles with a Start-stop system:
connect one end of the black jump lead
X
to a suitable ground terminal, to a sol-
id piece of metal in the engine block, or
to the engine block itself
›››
Fig. 47 .
»
1.
2.
3.
4a.
4b.
51