Seat Tarraco 2020, Owner'S Manual

Page: 348 / 424

Practical tips
 and 
They light up red
The engine cannot be restarted! Fault in the
AdBlue system.
Contact a specialised workshop. Have the system
checked there.
 It lights up yellow
The AdBlue reserve is low.
Refill AdBlue within the next kilometres (or miles) that
are indicated
›››
page 346 . SEAT recommends con-
tacting a specialised workshop.
 and 
They light up yellow
There is a fault in the AdBlue system or unsuitable
AdBlue fluid has been used.
Contact a specialised workshop. Have the system
checked there.
Several warning and control lamps should
light up for a few seconds when the ignition is
switched on, signalling that the function is be-
ing verified. They will switch off after a few
seconds.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 81 .
Fill AdBlue ®
Fig. 308
AdBlue tank cap.
Operations prior to refilling
Park the vehicle on a flat surface and turn off
the ignition. If the vehicle is on a slope or on a
curb, the level indicator may not detect the
refill properly.
If a warning message about AdBlue
®
levels
appears on the dash panel display, fill at
least the minimum amount required (ap-
prox. 5 litres)
Only after adding this amount
will the system detect that AdBlue ® has been
added and you will be able to start the en-
gine again. The maximum amount that can
be refilled is 11 litres.
Fill with a refill bottle
Only use AdBlue
®
that complies with ISO
22241-1. Only use original containers.
●
Open the tank cover
›››
Fig. 308 .
● Unscrew the tank cap by turning it in an an-
ti-clockwise direction.
●
Please observe the manufacturer's instruc-
tions, indicated on the refill bottle.
●
Check the expiry date.
●
Remove the cap of the refill bottle.
●
Insert the neck of the bottle in the tank filler
neck vertically and screw the bottle on by
hand, by turning it in a clockwise direction.
●
Press the refill bottle in the direction of the
filler neck and hold it in this position.
●
Wait until the contents of the refill bottle
have been poured into the AdBlue ® tank. Do
not compress or break the bottle!
●
Turn the bottle in a counter-clockwise di-
rection and gently pull it upwards
›››
.
●
The AdBlue ® tank is full when no more liquid
comes out of the bottle.
●
Screw on the tank cap in a clockwise direc-
tion until it is tightly closed.
● Close the fuel tank flap.
Operations before driving
●
After refilling the tank, only switch on the ig-
nition.
●
Leave the ignition on for at least 30 sec-
onds for the system to detect the fluid load.
●
Make sure you wait for at least 30 seconds
before starting the engine!
346