Seat Tarraco 2020, Owner'S Manual, Page: 165 / 424

Air conditioning
●
Always keep the remote control, keyrings
with batteries, the spare batteries, button
batteries and all other batteries over 20
mm out of reach of children.
● If you suspect that someone may have
swallowed a battery, seek immediate med-
ical attention.
CAUTION
●
The radio frequency remote control con-
tains electronic components. Therefore,
avoid getting it wet and exposing it to
knocks or direct sunlight.
●
The use of inappropriate batteries may
damage the radio frequency remote con-
trol. For this reason, always replace the
used battery with another of the same volt-
age, size and specifications.
For the sake of the environment
●
Please dispose of your used batteries
correctly and with respect for the environ-
ment.
●
The remote control battery may contain
perchlorate. Observe the legal provisions
regarding disposal.
●
Care should be taken so as not to oper-
ate the remote control unintentionally so
as to prevent the auxiliary heater being
switched on accidentally.
Programming the auxiliary heater*
Before programming it, check that the vehi-
cle's date and time are set correctly
›››
.
The auxiliary heater is programmed in the
Auxiliary heater
menu of the infotainment
system.
Open the
Auxiliary heater
menu.
●
Press the

button of the Climatronic
control panel.
●
Press the

function button.
Function button: function
Switch off
: The auxiliary heater is immediately
switched off.
Heat
,
Ventilate
: Set to heat or ventilate the vehi-
cle interior when the auxiliary heater is switched on.
Press the function button

to select the desired
mode.
Set
: Opens the
Auxiliary heater
menu.
Function button: function
Departure time 1
,
Departure time
2 , Departure time 3 : Three different de-
parture times (hh.mm) may be programmed. If
the auxiliary heater should only be switched
on a certain day of the week, this can also be
selected.
Duration
: The duration determines the oper-
ating time of the auxiliary heater when switch-
ed on using the fast heating button

on the
air conditioning controls. The duration is also
used to calculate the departure time for the
manual air conditioner. It can be set between
10 and 60 minutes at 10-minute intervals.
The programmed departure time determines
the approximate time it should take to reach
the temperature set in the vehicle. The start of
the heating operation is determined automat-
ically depending on the outside temperature.
Checking the programming
When a departure time is activated and the
ignition is switched off the control lamp of the
fast heating button

lights up for approxi-
mately 10 seconds.
WARNING
Never programme the auxiliary heater so
that it switches itself on and is running in an
enclosed space or an area with no ventila-
tion. The auxiliary heater exhaust fumes
contain carbon monoxide, an odourless
and colourless toxic gas. Carbon monoxide
»
163