Seat Tarraco 2020, Owner'S Manual

Page: 101 / 424

Opening and closing
Emergency unlocking or locking of
the driver’s door
Fig. 80
Driver door handle: Concealed lock
cylinder.
Fig. 81
Driver door handle: lever the cover off
If the central locking system should fail to op-
erate, the driver door can still be locked and
unlocked by turning the key in the lock.
As a general rule, when the driver door is
locked manually all other doors are locked.
When it is unlocked manually, only the driver
door opens. Please observe the instructions
relating to the anti-theft alarm system
›››
page 96 .
●
Unfold the vehicle key blade
›››
page 87 .
●
Insert the key shaft into the lower opening in
the cover on the driver door handle
›››
Fig. 81
then remove the cover upwards.
●
Insert the key blade into the lock cylinder to
unlock or lock the vehicle.
Special characteristics
●
The anti-theft alarm will remain active
when vehicles are unlocked. However, the
alarm will not be triggered
›››
page 96 .
●
After the driver door is opened, you have 15
seconds to switch on the ignition. Once this
time has elapsed, the alarm is triggered.
●
Switch the ignition on. The electronic immo-
bilizer recognises a valid vehicle key and de-
activates the anti-theft alarm system.
Note
The anti-theft alarm is not activated when
the vehicle is locked manually using the
key shaft
›››
page 89 .
Emergency lock of doors without
lock cylinders
Fig. 82 Locking the door manually.
If the central locking system should fail to
work at any time, doors with no lock cylinder
will have to be locked separately.
The emergency lock is located on the front of
the front passenger's door and the rear
doors. It can only be seen if the door is open.
●
Insert the key in the inside slot and turn it to
the right as far as it will go (if the door is on
the right side) or to the left (if the door is on
the left side).
Once the door has been closed it can no lon-
ger be opened from the outside. Pull the inte-
rior door handle once to unlock and open the
door.
99