Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
❑ Inserted into cylinder head.
Note
♦
Versions with or without oil
strainers are used depending on
build date.
♦
If no strainer was installed at the
factory, a strainer is instead inte‐
grated in camshaft control valve
1 - N205- .
♦
Damage may result if the strainer
is installed in both locations!
16 - Oil seal
❑ For inlet camshaft
❑ Replace
⇒ “3.5.1 Removing and installing camshaft oil seal for inlet camshaft, belt pulley end”, page 111
17 - Oil seal
❑ For exhaust camshaft (pulley end)
❑ Replace
⇒ “3.5.2 Removing and installing exhaust camshaft oil seal, pulley end”, page 113
18 - Sealing cap
Camshaft housing - tightening torque and sequence
Note
Renew bolts that are tightened with specified further tightening
angle.
– Tighten bolts in stages in the sequence shown:
stage
Bolts
Tightening torque/angle specification
1.
-1 … 15-
10 Nm
2.
-1 … 15-
turn 180° further
1.3
Removing and installing cylinder head
Special tools and workshop equipment required
♦ Socket and key - 3410-
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
72
Rep. gr.15 - Cylinder head, valve gear
