Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Work sequence
– Cut through the exhaust pipe at a right angle at the position
marked -arrow- using chain pipe cutter - VAS 6254- .
– When installing, position clamp centrally (-dimension a-) be‐
tween side marks -arrows-.
– Align exhaust system without tension
⇒ “1.4 Align exhaust system to be free of stress”, page 261
1.3
Removing and installing silencers
⇒ “1.3.1 Removing and installing front silencer”, page 259
⇒ “1.3.2 Removing and installing rear silencer”, page 260
1.3.1
Removing and installing front silencer
Removing
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
– Detach tunnel cross-piece (rear) -2-.
Separating point without clamp
– Separating silencer
⇒ “1.2 Disconnecting exhaust pipes/silencers”, page 257
Separating point with clamp
– Loosen clamp at rear, and push it to rear.
– Detach front silencer from rubber mounting.
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
1. Exhaust pipes/silencers
259
