Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
2.3.2
Removing and installing injectors, Con‐
tinental
Special tools and workshop equipment required
♦ Tool set for FSI engines - T10133 C- with -T10133/16 A- and
-T10133/19-
Removing
Note
♦
Risk of malfunction due to different procedures for installing
the injector seals.
♦
Depending on the vehicle type, production date and injection
pressure, injectors from different suppliers may be used.
♦
Identify the part number or the relevant supplier as follows:
♦
Allocation is done using ⇒ Electronic parts catalogue .
Identifying supplier or part number:
Position -A-: Information of the supplier.
Item -B-: part number.
Note
♦
Risk of functional impairment due to soiling.
♦
⇒ “3.1 Rules for cleanliness”, page 4
♦
Injectors must only be installed when the engine is cold.
Note
Injectors must only be installed when the engine is cold.
– Now remove the intake manifold
⇒ “4.2 Removing and installing intake manifold”, page 229
.
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
218
Rep. gr.24 - Mixture preparation - injection
