Seat Ateca 2018, Owner'S Manual

Page: 63 / 412

The essentials
How to jump start: description
Fig. 82 Diagram of connections for vehicles
without Start Stop system
Fig. 83
Diagram of connections for vehicles
with Start Stop system
Jump lead terminal connections
Switch off the ignition of both vehicles
›››
.
1.
Connect one end of the red jump lead to
the positive
+
terminal of the vehicle
with the flat battery
A
›››
Fig. 82 .
Connect the other end of the red jump
lead to the positive terminal
+
in the ve-
hicle providing assistance
B
.
In vehicles without a Start-Stop system:
connect one end of the black jump lead
to the negative terminal
–
of the vehicle
providing the current
B
›››
Fig. 82 .
In vehicles with a Start-stop system:
connect one end of the black jump lead
X
to a suitable ground terminal, to a sol-
id piece of metal in the engine block, or
to the engine block itself
›››
Fig. 83 .
Connect the other end of the black jump
lead
X
to a solid metal component bol-
ted to the engine block or to the engine
block itself of the vehicle with the flat
battery. Do not connect it to a point near
the battery
A
.
Position the leads in such a way that
they cannot come into contact with any
moving parts in the engine compart-
ment.
Starting
Start the engine of the vehicle with the
boosting battery and let it run at idling
speed.
2.
3.
4a.
4b.
5.
6.
7.
Start the engine of the vehicle with the
flat battery and wait for 2 or 3 minutes
until the engine is running.
Removing the jump leads
Before you remove the jump leads,
switch off the dipped beam headlights if
they are switched on.
Turn on the heater blower and heated
rear window in the vehicle with the flat
battery. This helps minimise voltage
peaks which are generated when the
leads are disconnected.
When the engine is running, disconnect
the leads in reverse order to the details
given above.
Make sure the battery clamps have sufficient
metal-to-metal contact with the battery ter-
minals.
If the engine fails to start after about 10 sec-
onds, switch off the starter and try again after
about 1 minute.
WARNING
●
Please note the safety warnings referring
to working in the engine compartment
›››

page 348 .
●
The battery providing assistance must
have the same voltage as the flat battery
»
8.
9.
10.
11.
61