Seat Ateca 2018, Owner'S Manual

Page: 295 / 412

Driver assistance systems
Trailer mode
When driving with trailer the ACC controls
less dynamically.
Overheated brakes
If the brakes overheat, for example after
abrupt braking or in long and steep slopes,
the ACC may be deactivated temporarily.
The relevant text message will appear in the
dash panel display. In this case, adaptive
cruise control cannot be activated.
Adaptive Cruise Control can be reactivated
once brake temperature has cooled suffi-
ciently. The message will disappear from the
instrument panel display. If the message
ACC
not available remains on for quite a long
time it means that there is a fault. Contact a
specialised workshop. SEAT recommends vis-
iting a SEAT dealership.
WARNING
If you do not heed the
Press the brake
message, the vehicle may initiate an invol-
untary movement and could crash into the
vehicle ahead. In any event, before driving
off, check that the road is clear. The radar
sensor may not detect obstacles on the
road. This could cause an accident and se-
rious injuries. If necessary, apply the brake.
Lane Assist system*
Introduction
Fig. 266
On the windscreen: field of vision of
the Lane Assist system camera.
Using the camera located in the windscreen,
the Lane Assist system detects the possible
lines dividing the lanes. When the vehicle in-
voluntarily approaches a dividing line it has
detected, the system notifies the driver with a
corrective steering movement . The purpose is
not only to warn the driver, but also to keep
the vehicle inside the lane. This movement
can be over-regulated at any time.
No warning is produced with the turn signals
activated, given that the Lane Assist system
understands that a lane change is required.
Control lamp
 It lights up yellow
Lane Assist active but not available.
The system cannot accurately recognise the lane.
Please see page 295 , Lane Assist system is not avail-
able (the control lamp is lit up yellow).
 It lights up green
Lane Assist system active and available.
Some control and warning lamps will light up
briefly when the ignition is switched on to
check certain functions. They will switch off
after a few seconds.
WARNING
Observe the safety warnings
›››
in Con-
trol and warning lamps on page 124 .
293