Seat ALTEA XL, Owner'S Manual

Page: 245 / 297

If and when 244
Raising the vehicle
In order to remove the wheel, the vehicle must be raised with
a jack.
– Locate the jacking point under the door sill closest to the wheel
to be changed
⇒
fig. 173 .
– Place the jack under the jacking point and turn the crank until the
arm of the jack is directly below the vertical rib under the door
sill.
– Align the jack so that the arm of the jack fits around the rib under
the door sill and the movable base plate of the jack is flat on the
ground
⇒
fig. 174 .
– Raise the jack until the defective wheel is just clear of the ground.
Recesses at the front and rear of the door sills mark the jacking points
⇒
fig. 173 . A position has been made for each wheel. Do not fit the jack
anywhere else.
An unstable surface under the jack may cause the vehicle to slip off the jack.
Therefore, the jack must be fitted on solid ground offering good support. Use
a large and stable base, if necessary. On a hard, slippery surface (such as
tiles) use a rubber mat or similar to prevent the jack from slipping.
WARNING
•
Take all precautions so that the base of the jack does not slip. Failure to
do so could result in an accident.
•
The vehicle can be damaged if the jack is not applied at the correct
jacking points. There is also a risk of injury since the jack can slip off
suddenly if it is not properly engaged.
Fig. 173 The jacking
points
Fig. 174 Fitting the jack
AlteaXL_EN.book Seite 244 Montag, 2. Februar 2009 12:26 12