Seat Alhambra 2019, Owner'S Manual

Page: 309 / 380

Towing bracket device*
Retrofitting a towing bracket
Description
Fig. 280
Limits and attachment points for ret-
rofitting a towing bracket.
SEAT recommends that towing brackets be
retrofitted at a specialised workshop. For ex-
ample, it may very well be necessary to ad-
just the cooling system or mount thermal pro-
tection plates. SEAT recommends visiting a
SEAT dealership for this.
If a towing bracket is retrofitted, the distance
specifications should always be kept in mind.
The distance between the centre of the ball
head and the road
›››
Fig. 280
D
must never
be less than indicated. This also applies when
the vehicle is fully loaded, including the tech-
nically permissible maximum vertical load on
the coupling device.
Separation distances
›››
Fig. 280 :
Attachment points (lower part of the vehi-
cle)
1,040 mm (41 inches)
74 mm (3 inches)
364 mm (14 inches)
247 mm (10 inches)
596 mm (23 inches)
1,097 mm (43 inches)
1,102 mm (43 inches)
WARNING
If the cables are improperly or incorrectly
connected, this may lead to malfunctions
in the entire vehicle electronic system, as
well as to accidents and serious injuries.
● Never connect the trailer's electric sys-
tem to the electrical connections of the tail
A
B
C
D
E
F
G
H
lights or any other unsuitable power sour-
ces. Only use suitable connectors to con-
nect the trailer.
● The towing bracket should be retrofitted
only at a specialised workshop.
WARNING
If the towing bracket is badly fitted or un-
suitable, the trailer may separate from the
vehicle while driving. This could cause seri-
ous accidents and fatal injuries.
Note
●
Only use towing brackets that have been
approved by SEAT for the model in ques-
tion.
●
In some versions, the fitting of a conven-
tional towing hook solution is not recom-
mended. Please consult your Technical
Service.
307